VT2516A | VT2516A FPGA

Digital Module

The VT2516A module is connected to up to 16 mainly digitally used I/Os of an ECU, i.e. for signals with 2 states. In real vehicles for example, coding connectors, switches or signal lamps may be connected to these pins. This module is also available as a variant (VT2516A FPGA) with user programmable FPGA.

Digital Module: VT2516A | VT2516 FPGA

Characteristics:
VT2516A

Functions for Each Channel

  • Various signal paths to the original sensor or the original actuator are switched via relays and are connected to a bus bar. The relays may be used, for example, to disconnect the line (broken wire simulation).
  • Relay for short circuit between an input line and ground or battery voltage
  • Relay for a connected external load, pull-up or pull-down resistor
  • Sampling of a digital input value with configurable voltage threshold
  • Determination of PWM signal parameters (frequency and duty cycle)
  • Voltage measurement with calculation of instantaneous and average values
  • Digital output with adjustable high and low levels
  • Autonomous output of a bit stream loaded into module
  • Generation of a PWM signal

Technical Data

VT2516A
  Input voltage -40 V … +40 V
  Input current (via relays) Max. 800 mA
Input of digital signals
  Threshold 0 … 25 V
  Hysteresis  Approx. 1 V
  Sampling interval 50 µs
  PMW frequency (PWM measurement) 20 mHz … 200 kHz
Voltage measurement
  Accuracy (at 25 °C) ± (0.5 % + 150 mV)
  A/D converter (per channel, internal) 12 Bit / 1 kSamples/s
Output of digital signal
  High level, low level 0 … 25 V
  Accuracy (at 25 °C) ± (0.5 % + 200 mV)
  Slew rate (resistive load, 10 mA) Typ. 20 V/µs
  Output current Max. 30 mA
  Length of bit stream 2 … 4,096 Bit
  Output of interval 2 µs … 65 ms
  Frequency of generated PWM signal 20 mHz … 25 kHz
Basic Data
  Supply voltage (via backplane) 12 V ±10 %
  Power consumption (all relays off) Typ. 8 W
  Power consumption (32 relays active) Typ. 13 W
  Temperature range 0 … 55 °C
  Dimensions (L x W x H) 300 x 173 x 36 mm
  Weight Approx. 540 g
Maintenance
  Calibration recommended every 12 months
  Accredited (pre/re) calibration according to ISO/IEC 17025:2017

Schematic

Schematic of one channel of the VT2516A

Related Products

VT System | HIL Test Platform

Scalable and modular systems for HIL testing in various industries

Go to Page