MeasurementECU, Busses, ADAS-Sensors and More
Navigation de page
- Début de la page
Reliable Recording of Measurement Data
Whoever acquires measurement data from a variety of sources needs a reliable system that records data in a time-synchronized manner. The Vector solutions give you access to the following:
Your Tools for ECU and Bus Measurement
The following tools facilitate the time-synchronized real-time acquisition:
CANape – The All-Round Tool for Measurement of Nearly All Kinds of Data
CANape log – Use your CANape configurations directly in this logger
vMeasure exp – Reliably solving complex measurement tasks with focus on analog measurement
vMeasure log - Use your vMeasure exp configurations directly in this logger
VX1000 – Scalable measurement and calibration hardware for ECUs and ADAS sensors
XCP Driver – Embedded solution for access to ECU internal data
Network Interfaces - Interfaces to connect your PC with CAN / CAN FD, LIN, J1708, Ethernet, FlexRay as well as 802.11p
CANape is the Swiss Army Knife to measure nearly everything. Everywhere.
More information on CANape
ECU Relevant Interfaces
The VX1000 system is a scalable solution with maximum performance for your measurement and ECU calibration tasks. It forms the interface between the ECU and a measurement and calibration tool such as CANape. For high data throughput with minimum runtime effects on the ECU, access is by means of microcontroller-specific data trace and debug interfaces.
More information on VX1000
The XCP driver allows access to the controller internal memory for measurement and calibration via the ASAM standard protocol XCP.
- More information on XCP Driver
Scalable service-Oriented MiddlewarE over IP is a communication protocol that supports remote procedure calls, event notifications, and the underlying network. In service-oriented data transmission, a sender transmits data only if at least one receiver on the network has subscribed to it. It’s supported in CANape.
- More information on SOME/IP
AUTOSAR DLT (Diagnostic, Log and Trace)
The DLT Module is a software module that collects debug information from applications or other software modules inside the ECU. Metadata are added to the debug information. All information were transmitted via Ethernet.
- More Information on AUTOSAR DLT
The access to the diagnostic data and services via diagnostic protocols UDS and KWP2000 rounds off the view of the processes in the control unit.
- More information on Diagnostic Access