MeasurementECU, Busses, ADAS-Sensors and More
Navegação na página
- Início da página
Reliable Recording of Measurement Data
Whoever acquires measurement data from a variety of sources needs a reliable system that records data in a time-synchronized manner. The Vector solutions give you access to the following:
Your Tools for ECU and Bus Measurement
The following tools facilitate the time-synchronized real-time acquisition:
CANape – The All-Round Tool for Measurement of Nearly All Kinds of Data
CANape log – Use your CANape configurations directly in this logger
vMeasure exp – Reliably solving complex measurement tasks with focus on analog measurement
vMeasure log - Use your vMeasure exp configurations directly in this logger
VX1000 – Scalable measurement and calibration hardware for ECUs and ADAS sensors
XCP Driver – Embedded solution for access to ECU internal data
Network Interfaces - Interfaces to connect your PC with CAN / CAN FD, LIN, J1708, Ethernet, FlexRay as well as 802.11p
ECU Relevant Interfaces
The VX1000 system is a scalable solution with maximum performance for your measurement and ECU calibration tasks. It forms the interface between the ECU and a measurement and calibration tool such as CANape. For high data throughput with minimum runtime effects on the ECU, access is by means of microcontroller-specific data trace and debug interfaces.
More information on VX1000
The XCP driver allows access to the controller internal memory for measurement and calibration via the ASAM standard protocol XCP.
- More information on XCP Driver
Scalable service-Oriented MiddlewarE over IP is a communication protocol that supports remote procedure calls, event notifications, and the underlying network. In service-oriented data transmission, a sender transmits data only if at least one receiver on the network has subscribed to it. It’s supported in CANape.
- More information on SOME/IP
AUTOSAR DLT (Diagnostic, Log and Trace)
The DLT Module is a software module that collects debug information from applications or other software modules inside the ECU. Metadata are added to the debug information. All information were transmitted via Ethernet.
- More Information on AUTOSAR DLT
The access to the diagnostic data and services via diagnostic protocols UDS and KWP2000 rounds off the view of the processes in the control unit.
- More information on Diagnostic Access