VX1000 Measurement and Calibration Hardware
Functions:
- DAQ event triggering by a single memory write access
- Only minor modification of ECU code needed
- Minimal influence on ECU execution times
- Option for generating time stamps in ECU
- Read/Write access to ECU internal memory without address limitations
- Very short stimulation and bypassing latency times
- Flash programming of “brain dead” ECUs
- 100 Mbit/s Ethernet connection to PC
- PC tool for configuration and software updates
Modular Concept:
The VX1000 system consists of the following modules:
- VX1100 - Base Module
- VX1121 - Base Module + 4 CAN monitoring channels
- VX1200 - ECU Interface Modules
- VX1300 - Cables
- VX1400 / VX1500 - Microcontroller-specific PODs (Plug-On Device)
When used in the engine compartment, a POD is either tightly coupled to the ECU housing or even resides within. The POD is connected to the Base Module with a plugged-in ECU Interface using a cable of up to 5 m in length.
POD and cable are designed for the tough automotive environment. They resist high temperatures and have watertight connectors. The POD can be mechanically and electrically adapted to the ECU based on your requirements.