ODX: State dependency templates are now created with a meaningful state dependency pre-set (UDS and VW)
GUI: DTC Setting Dialog now also supports float values
GUI: If the protocol standard can not be detected in the diagnostic data then the user is allowed to select it manually
GUI: Import in CANoe for Non-CAN network now informs the user to configure the diagnostic options manually
Test: Sweep does now consider service specifics (e.g. for Routine and IO Control)
Test: ServiceAndIdScanner test is now also available for Non-CAN networks
Test: Scan-Ranges can now be excluded from ServiceAndIDScanner test
Report Analysis: A Requirement Overview now provides a printable requirement-oriented view of the test results
Report Analysis: Enabled horizontal scrolling for Trace Window
Issues solved:
GUI: When loading a CANoe.DiVa 2.2 test report to CANoe.DiVa 2.5 an incorrect "The report is not a result of the last generated test module" is prompted
GUI: Data Customization: Problems fixed with arrays > 250Bytes and parameters of undefined max. size
GUI: Data Customization: "Show Only selected Services" did not work in all cases
GUI: Data Customization: Editing a parameter with a range which has no lower/upper limit was not supported
GUI: Sometimes it was not possible to delete all sweep value ranges
Test: It was not always waited (if configured) after a Clear DTC request
Test: Automatic DTC Setting: A warning is now written to the test report if an active stimulation is not restored at test end
Test: GM: The ControlDTCSetting service was not used in SimpleRequest tests