Development & Test Tool CANoe.IP

Option .IP extends the functional range of CANoe by adding Ethernet-specific functions and the ability to transmit CAN messages via WLAN or Ethernet.

Configuration of up to four Ethernet channels (10/100/1000 Mbps)
Support of Ethernet and Ethernet-based protocols such as IP, UDP and TCP
Various filter options (Hardware/Measurement Setup/View)
Display of protocol header information in the Trace Window
Use of your own signal protocol decoder DLLs
Interactive Generator Block for Ethernet and Ethernet Packet Builder for configuring and sending Ethernet packets
Nodelayer DLL for accessing Ethernet from CAPL and .NET
Separate TCP/IP communication software instances for each CAPL node
Configurable exclusive use of Ethernet interfaces by CANoe.IP
Logging of data traffic, including Rx/Tx direction and channel

Remote CAN Analysis

Transparent transmission of CAN messages via WLAN (requires additional hardware and the bus system option CAN)

Did you find this page helpful?