Analysis with CANoe

CANoe provides you with the following analysis windows and function blocks:

Measurement Setup for graphic display and parameterization of function blocks and evaluation functions
Trace window to trace all bus activities such as messages or error frames. It is possible to display the individual signal values for each message.
Graphic window for graphic online display of the values trans-ferred in the messages and diagnostic requests, such as engine speed or temperature, over a time axis
Data window to display preselected data, e.g. numerically or as a bar graph
Statistics Monitor to display message rates, error rates, bus utilization and CAN controller states
State Tracker window to display states and bit signals
Interactive Generator Block to stimulate the buses and send modified signals easily
Signal Generator to generate signal waveforms (sinusoidal, ramp, pulse, value list, etc.)
Logging/Replay to log and later analyze or replay measurements
Triggers and Filters for specific reactions to bus events and to reduce the quantity of displayed or logged data
Write for system messages and user-specific outputs from CAPL programs

Did you find this page helpful?